Henry Model X Handguard Removal

by Maisie

To remove a Henry model X handguard, you will need to remove the handguard. First, you will need to unbolt the rail. You can do this easily by loosening the handguard screws. Then, you will need to turn off the safety to allow the removal of the handguard. Then, you will need to remove the rear sight and the rail. It is important to remove the old handguard before you proceed with the new one.

After you have removed the old handguard, you will need to remove the old one. The Henry handguard is designed to be easily removed. You can do it yourself or hire a gunsmith to do it. It is highly recommended to have a qualified gunsmith install it for you. Once you’ve removed it, you will need to remove it with the help of a screwdriver. If the hole is still too small, you will need to use a screwdriver to unscrew the old one.

The Henry handguard is very similar to those found on Marlin MLOK handguards. You can install it yourself using simple tools. However, if you’re not confident in your gunsmithing skills, you’ll have to call a gunsmith to do the job for you. You should also consider hiring a gunsmith to install the Henry handguard, as this is a complex piece of equipment.

Another difference between the Henry model X handguard and the Midwest Industries handguard is the M-LOK attachment. The Henry M-LOK handguard can be installed on the same gun, but the installation process is more complex. The Marlin handguard can be installed by a layperson in less than 10 minutes with simple tools. The Henry handguard will require the assistance of a gunsmith, so if you don’t feel confident with your DIY skills, consider hiring a gunsmith.

If you are not confident in your gunsmithing abilities, consider getting a gunsmith to install it for you. Typically, you can do the job yourself, but it’s better to get a professional gunsmith to install it. The Midwest Industries Henry handguard is similar to the M-LOK, but is a little more difficult to install. Fortunately, you can purchase and install it yourself.

Final Touch

If you’re installing an M-LOK handguard on your Henry model X, you will need to remove the original handguard. Aside from this, you’ll need to remove the front sight and the M-LOK. These two attachments are not compatible. You’ll need to visit a gunsmith to install your handguard. The Midwest Industries handguards are compatible with all Henry models.

You may also like

Leave a Comment